HOME ABOUT US MEMBER COMPANIES THE MANY REASONS TO USE STEEL WINDOWS AND DOORS SPECIFICATIONS / INSTALLATION PRODUCTS REPLACEMENT VS. RESTORATION RECYCLABILITY STATEMENT FAQ's CONTACT US     GENERAL SPECIFICATIONS ARCHITECT'S GUIDE TO STEEL WINDOWS SPECIFICATIONS: COLD ROLLED SPECIFICATIONS: HOT ROLLED GUIDELINES ON HOW TO INSTALL STEEL WINDOWS   GENERAL GUIDELINES FOR THE INSTALLATION OF STEEL WINDOWS AFTER THE WINDOW IS INSTALLED If steel windows are properly installed and maintained, it is possible for them to last the life of the building. After the window is installed, verify that the window operates correctly. Handles, stays and catches should be checked for proper operation and should move freely. Operable vents must operate smoothly and close tightly. Rubber weather seals should not have any nicks, tears or cuts. Make any adjustments necessary or as recommended by the window manufacturer. Any scratches or digs in the paint finish should be repaired with touch up paint as recommended by the window manufacturer. Check to make sure that any drain holes in the outer frame sill are clear and unobstructed to insure correct window weather performance. Once the window operates satisfactorily, clean the window using a mild non-alkaline soap and warm water, applied with a sponge or soft cloth. Rinse with clear water. © The Steel Window Institute (2006) Contents are the property of the Steel Window Institute, its members or others who have licensed the information. All rights reserved.   GENERAL GUIDELINES ON HOW TO INSTALL STEEL WINDOWS LINKS GETTING STARTED THE OPENING PLACING WINDOW INTO OPENING FASTENING WINDOW SEALING EXTERIOR PERIMETER GAP GLAZING WINDOW WITH GLAZING BEADS GLAZING FIRE RATED WINDOWS. AFTER WINDOW IS INSTALLED